DP83TD510E-EVM: cannot start up EVM

Takuya Terada

Expert 5915 points

Part Number: DP83TD510E-EVM
Other Parts Discussed in Thread: DP83TD510E, DP83822I

Hi team,

My customer try to use our EVM, but he cannot evaluate it.

when board connect to PC, it looks like attached picture.

could you give some advice?

best regards,

Takuya

over 5 years ago

0 Vikram Sharma over 5 years ago

TI__Genius 16030 points

Hello,

In the user guide following PHY IDs are mentioned:

"The DP83TD510E has been set to PHY address 00 and the DP83822I has been set to PHY address 05."

Are these PHY IDs getting detected? If not, can you please share the jumper settings used versus what is mentioned in section "Power Supply Selection".

Regards,

Vikram

0 Takuya Terada over 5 years ago in reply to Vikram Sharma

TI__Expert 5915 points

the problem was Customer's driver so this problem was solved.

thanks

Interface

Interface forum

DP83TD510E-EVM: cannot start up EVM