I need to input power into my system at more than 5V, how do I do this?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Below is a block diagram with the minimum set passive components to implement a UFP (Sink) using the TPS25750D
Design Consideration Checklist:
Please refer to section 12 Layout on page 55 of the TPS25750 USB Type-C and USB PD Controller with Integrated Power Switches datasheet (Rev. A) for a representative schematic and layout recommendations.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs and
embedded processors, along with software, tools and the industry’s largest sales/support staff.