SN74LVT245B: When OE is Lo at power up

Hiroaki Yuyama TED

Expert 1840 points

Part Number: SN74LVT245B

Tool/software:

Dear, Logic Support team.

If the OE# and A[n] pins are connected to GND,

could you let me know the behavior of Y[n] pin during Vcc ramp up from 0V to 2.7V?

Best Regards,
Hiroaki Yuyama

over 1 year ago

0 Clemens Ladisch over 1 year ago

Guru 327960 points

For supply voltages between 0 V and 1.5 V, the outputs are disabled.
For supply voltages between 1.5 V and 2.7 V, correct behaviour of the DIR input or the outputs on either side is not guaranteed. If your circuit cannot handle that, pull /OE high during power up.

0 Hiroaki Yuyama TED over 1 year ago in reply to Clemens Ladisch

Expert 1840 points

Hi,Clemens-san.

Thank you for your reply.
Your answer helped me understand the output behavior when OE is Lo.
If our customer cannot accept this, we will set OE to Hi and start the power supply.

Best Regards,
Hiroaki Yuyama

Logic

Logic forum

SN74LVT245B: When OE is Lo at power up