TPLD-PROGRAM: TPLD-PROGRAM MER Non-Functional After Update

Yes - bought more than one - not going to 'brick' this one - maybe these are stuck in DFU mode after this update????

Appears stuck here.

TI,

For the TPLD-Programmer I was having an issue with - I did this:

1)  Carefully popped the cover off.
2)  Held down the RESET (and boot) switches while powering on the unit or the 'classic' get it unstuck from DFU mode or whatever mode it was in.
3) Started ICS (again) - and it happily proceeded with the firmware update.

Suggestions:
The order in which people are given - unplug programmer, etc - may become out of sync with what's actually going on.
I've managed to 'crash' ICS more than once - appears to be not so stable right now - is there a repo or a place where we can report bugs?
TI used to have this for CCS and other tools.
One of the issues - the package RWS/RWB doesn't appear to be 'sticky' - enough - should be.
The unit should not program if it's loaded (or changes) to the wrong device - we shouldn't even be able to 'burn' a device if the 'wrong' one is loaded -
wrong here also means the config got changed out from under the user. 
I've also seen instances where ICS says the part has been programmed or the part is 'burned' - and that's absolutely incorrect.

Best Regards,
John W.

Hi John,

Let me take a look through your responses and get back to you.

Regards,

Kollin Ewing