How to split an 86Mhz signal??

BH4636

Other Parts Discussed in Thread: SN74ALVCH162830, TS3DV621

I need to drive 2 loads with the 24 bit parallel RGB video signal from an OMAP 3530. I will have a max frequency of 86MHz. Can I use a logic chip like the SN74ALVCH162830 to do this or is there a better way? Thanks

over 11 years ago

0 Chris Cockrill over 11 years ago

TI__Mastermind 46480 points

you are good up to 150Mhz on the ALVCH162380. I am not sure if you need a buffered part or a switch for RGB. The OMAP guys may be able to guide you.

In case you need a switch here is and option. SN74CBTLV16292

0 Greenja over 11 years ago in reply to Chris Cockrill

Guru 22270 points

Would the TS3DV621 be applicable here? It would require two of though.

How/where is the 150MHz speed found on the data sheet?

Because of the holidays, TI E2E™ design support forum responses will be delayed from Dec. 25 through Jan. 2. Thank you for your patience.

Logic

Logic forum

How to split an 86Mhz signal??