Logic

Logic forum

TXS0108E: using in I2C and SWD application at same time

Rohit Gujarathi

Prodigy 40 points

Part Number: TXS0108E
Other Parts Discussed in Thread: TXB0108,

Hello,

I have an application where i need to convert from 3.3V to 1.8V logic levels. The signals i need to convert are I2C, USART and SWD at the same time. Is it possible to it with this IC?

Also, what is the difference between TXS0108 and TXB0108?

thank you.

over 6 years ago

0 Emrys Maier over 6 years ago

TI__Guru* 96947 points

Hello Rohit,
The TXS0108E is probably the best option if you want to combine different protocols, but I'm not familiar with USART or SWD. I would need to know their architecture and bit rate to give you definitive answer.

0 Rohit Gujarathi over 6 years ago in reply to Emrys Maier

Prodigy 40 points

I need to interface the STM32F103 with NRF52. STM32 will be running at 3.3V and the NRF52 at 1.8V.

0 Emrys Maier over 6 years ago in reply to Rohit Gujarathi

TI__Guru* 96947 points

Architecture? Push-pull or open-drain
Bit-rate? Measured in bits per second

0 Rohit Gujarathi over 6 years ago in reply to Emrys Maier

Prodigy 40 points

SWD is push pull at about 4.5Mbps
UART at 115200kbps push pull and
I2C 400Kbps, open drain.

0 Emrys Maier over 6 years ago in reply to Rohit Gujarathi

TI__Guru* 96947 points

Those will all work fine without problems on the TXS0108E - assuming the capacitive loading isn't too crazy (< 70pF)

0 Rohit Gujarathi over 6 years ago in reply to Emrys Maier

Prodigy 40 points

great! thanks!