LSF0108: Switching Characteristics

Nanjunda M

Part Number: LSF0108

Hi,

I'm looking for the particular timing parameters for LSF0108:

tpd (Propagation delay time), ten (Enable time), tdis (Disable time), tSK(O) (Skew (time), output), tr (Input rise time), tf (input fall time)

Can anyone please help.

Thanks & Regards,

Nanjunda M

over 6 years ago

0 ShreyasRao over 6 years ago

TI__Guru 62180 points

Hi Nanjunda,

The LSF is passive device wherein the translation depends on the external pullup resistors. The input pullup resistors may or may not be used depending on the interface used.
The tpd, rise time, fall time depends on the output loading and the pullup resistor used. the stronger pullup results in faster (smaller rise time). the fall time depends on the input driver ability to pull the line low.
The tpd ( tplh and tphl) is given in the datasheet for different conditions.

0 Nanjunda M over 6 years ago in reply to ShreyasRao

Expert 2485 points

Hi ShreyasRao,

Thanks for the reply.

I have attached the schematics below:

We have a 511E pull-ups for a nominal current of about 5mA.

Could you please let me know, how to calculate the tpd, raise time & fall times from the above data available.

Thanks & Regards,

Nanjunda M

0 ShreyasRao over 6 years ago in reply to Nanjunda M

TI__Guru 62180 points

Nanjunda,

Please watch the up translation video on LSF here:
training.ti.com/TLM-LSF-Up

This explains the use of pullup resistance and capacitive loading on the output rise time and hence the tpd.

Logic

Logic forum

LSF0108: Switching Characteristics