SN74AXC4T245: Connections

d_zero

Genius 4805 points

Part Number: SN74AXC4T245

Dear *,

1) we are not using all the pins eg. pin9 and pin12, what is the proper connection lave floating or connect to GND?

2) We have DIR1 direct connected to VCCA and DIR2 direct connected to GND, and both OE are direct connected to GND.

Best Regards,

over 6 years ago

0 ShreyasRao over 6 years ago

TI__Guru 62250 points

Hi D,

I assume that you are talking about the RSV package on pin 9 and 12.
I would advise to have all the unused IO ports at gnd.
Yes, the OE/DIR pins can be connected to gnd or vcca without pullup or pulldown. They are CMOS inputs and consume very little leakage current.

May I know the application for which this device is being used?

0 d_zero over 6 years ago in reply to ShreyasRao

Genius 4805 points

Dear Shreyas,

yes we are using RSV package.

We are using this level translator for UART (TX, RX) and one IO signal.

Best Regards,
D.

0 ShreyasRao over 6 years ago in reply to d_zero

TI__Guru 62250 points

Thanks for the information, D.
There is an app note which you can refer too on the UART interface using the AXC here :
www.ti.com/.../scea065.pdf

Please let me know if you have any other questions.

Logic

Logic forum

SN74AXC4T245: Connections