Buffer to isolate MDIO

Patrick Chen

Other Parts Discussed in Thread: TXS0102

Hello

CPU have MDIO interface. While live insertion another extension board for MDIO connection, CPU MDIO line will be hang up by extension board. Has any buffer to solve this hang up issue while extension board insertion? Thank you.

Patrick

over 6 years ago

0 Adam Torma over 6 years ago

TI__Mastermind 45535 points

Patrick,

You could use a 2-channel 1:1 switch with powered off protection to help isolate the signal path. What do you think about the SN74CB3Q3306A?

Thank you,

Adam

0 Patrick Chen over 6 years ago in reply to Adam Torma

Mastermind 8875 points

Hello

Could TXS0102 also support powered off protection to help isolate the signal path? Thank you.

Patrick

0 ShreyasRao over 6 years ago in reply to Patrick Chen

TI__Guru 60720 points

Patrick,

TXS0102 guarantees Ioff partial power down mode.

With this, the IO ports are guaranteed to be in hi-Z mode when either one of the supply is at 0V. The IO ports can have active signals without accidently turning on the supply through the internal leakage paths.

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Logic

Logic forum

Buffer to isolate MDIO