2N7001T: Input/Output Waveform

Sadanori Kato

Part Number: 2N7001T

Hi,

Could you please share the screen capture for the input and output signal when 2N7001 works at 1MHz with 2N7001TEVM supplying 3.3V to VCCA and VCCB ?
Additionally, it would be helpful if you could also obtain an expanded waveform with focus on Tr and Tf.

Best regards,
Kato

over 5 years ago

0 ShreyasRao over 5 years ago

TI__Guru 58320 points

Hi Kato,

The 2N7001T is capable of handling greater than 50Mhz data rate, so 1Mhz shouldn't be much concern.

Is there any specific issue which i could address?

0 Sadanori Kato over 5 years ago in reply to ShreyasRao

Guru 36530 points

Hi Shreyas-san,

Thank you for your prompt reply.

I would like to obtain only overshoot and undersoot waveforms when changing from low to high and from high to low, so could you please share these waveforms with me ?

Best regards,
Kato

0 ShreyasRao over 5 years ago in reply to Sadanori Kato

TI__Guru 58320 points

Kato-san,

The IBIS models gives the behavior of the device for purposes of simulation or performance of overshoot/undershoot.

The EVM is to demonstrate the functionality of the device and not ideal for timing or transient analysis.

0 Sadanori Kato over 5 years ago in reply to ShreyasRao

Guru 36530 points

Hi Shreyas-san,

Thank you for the suggestion.

I understood.

Best regards,
Kato

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Logic

Logic forum

2N7001T: Input/Output Waveform