TXB0104: TXB0104 VCCA & VCCB connect with Single 1.8V source

Rajkumar kannan

Part Number: TXB0104

Hi ,

We are using TXB0104 and connected both VCCA & VCCB with 1.8V from single voltage source.

From datasheet, both timing requirements & switching characteristics show it works in both VCCA & VCCB connect with 1.8V.

But when we try with in my design, it is not properly working. Kindly need your support.

Regards,

P. Rajkumar.

over 5 years ago

0 Clemens Ladisch over 5 years ago

Guru 316780 points

V_CCA = V_CCB = 1.8 V is allowed.

Please ensure that you circuit complies with all requirements in sections 8.3.2/3/5 of the datasheet.

0 Rajkumar kannan over 5 years ago in reply to Clemens Ladisch

Prodigy 70 points

In our design we are using one high speed cable to connect with another board. The cable has capacitance nearly 120PF.

Whether the TXB0104 able to drive in that capacitance?

0 Clemens Ladisch over 5 years ago in reply to Rajkumar kannan

Guru 316780 points

Section 3 of A Guide to Voltage Translation With TXB-Type Translators says:

With regard to capacitive loads, TXB translators are designed to drive up to 70 pF without issue. If capacitive loading is larger than 70 pF, the O.S. will time-out after 10 ns and subsequently turn off before the output voltage is driven fully high or low. From there, the output will continue to rise or fall based on the RC time constant determined by the 4-kΩ buffer, load resistance and capacitive loading. To ensure reliable operation, system designers should keep capacitive loading for the TXB-type devices to 70 pF or less.

0 Rajkumar kannan over 5 years ago in reply to Clemens Ladisch

Prodigy 70 points

Thanks Clemens.

Logic

Logic forum

TXB0104: TXB0104 VCCA & VCCB connect with Single 1.8V source