TXS0104E: land pattern data of TXS0104ERGYR, 6×Φ0,3 but the picture was show only 4?

Jian Xiule

Part Number: TXS0104E

For the TXS0104ERGYR with RGY package, the land pattern data of TXS0104ERGYR, the statement is 6×Φ0,3, but there is only 4 hole on the picture. May I know where is the gap? details see below picture or the manual page 32

www.ti.com.cn/.../txs0104e.pdf

over 4 years ago

0 Dylan Hubbard over 4 years ago

TI__Mastermind 45725 points

Hey Jian,

I think the image stating "Example Via Layout Design may vary depending on constraints" means that it won't be exactly what is shown. This is mostly an example way of doing it, but it can be done in any way suits your design best. This isn't a high powered device so there shouldn't be much concern for high thermals.

0 Jian Xiule over 4 years ago in reply to Dylan Hubbard

TI__Prodigy 260 points

Hi Dylan,

Thanks for your detail feedback. Understand this is only an example. But for the mismatch, may I know why the picture have 4 thermals however the statement is 6? In my option, it should match although it is an example.

Have a good day.

Thanks and Best Regards

Jian, Sure

+1 Dylan Hubbard over 4 years ago in reply to Jian Xiule

TI__Mastermind 45725 points

Hey Jian,

Its likely the image is generic to fit multiple channel counts of this package. The image doesn't necessarily need to show 6 to convey the recommendation.

+1 Jian Xiule over 4 years ago in reply to Dylan Hubbard

TI__Prodigy 260 points

Hi Dylan,

Thanks for you patient.

Logic

Logic forum

TXS0104E: land pattern data of TXS0104ERGYR, 6×Φ0,3 but the picture was show only 4?