MSP432E401Y: Sysconfig Configuration generation for peripheral like EPI , Advance SSI not generating

Hello Atul Solvande,

On the right side you can see generated files, if you don't see the generated files click on the < > symbol in the top right corner. You will be able to see the changes instantly on the files there. ti_drivers_config.c might not be listed in the generated files, as the files are dependent on device. When you build the project the generated files will default to Debug/syscfg and update when you build the project. Here is a guide on working with Sysconfig in CCS that may be helpful as well.

Regards,

Luke

Hi Luke,

Thanks for reply. Actually the issue is different. The ti_driver_config.c file gets generated but the Reserve Periheral configuration is not getting generated. For e.g. if I add SPI configuration it is generated properly in file ti_driver_config.c file whereas addition of SSI don't generate any config data in file ti_driver_config.c file

Hi Atul,

Does this occur when adding the SSI alone or any combination of 2 or more configurations? or does this only occur when SSI is involved? Just to confirm, there are no errors on the config file (like pins being used for multiple functions)? 

sincerely,

Luke

Adding any combination or any single peripheral configuration from "reserve peripheral" category is not generated in ti_driver_config.c file

Hello Atul,

When I go through the Sysconfig I get the configuration files pinout.c, pinout.h, and untilted.syscfg for the MSP432E401Y device. These files are changing with additions of new peripherals and only update in the CCS project when I build the program. Do you see these files being generated or are you only seeing a ti_driver_config.c file?

I only see ti_driver_config.c file

Hello Atul,

Is your version of Sysconfig up to date or are you using a legacy version? Does this issue only occur on the CCS version or does it occur when you use the cloud version as well?

Regards,

Luke