TMS570LS3137: How to put the system into halt debug mode through software configuration

Cherry Zhou

Mastermind 22235 points

Part Number: TMS570LS3137

NOTE: The customer uses the TMS570LS3137 development board.

Many modules have emulation/debug mode, and the customer would like to know how to configure the system into this mode.

Thanks!

Best Regards,

Cherry Zhou

over 4 years ago

0 QJ Wang over 4 years ago

TI__Guru**** 199456 points

Hello,

On a debug event, such as a breakpoint or watchpoint, the debug logic stops the processor and forces it into debug state. This enables you to examine the internal state of the processor, and the external state of the system, independently from other system activity. When the debugging process completes, the processor and system state are restored, and normal program execution resumes.

Run mode is the normal mode of operation where all of the functionality of the processor is available.

0 Cherry Zhou over 4 years ago in reply to QJ Wang

TI__Mastermind 22235 points

Hi Wang,

Thanks for your reply!

May I know if there are other things that will cause the system to go into debug state besides setting breakpoints or watchpoints?

Thanks a lot!

Best Regards,

Cherry

0 Cherry Zhou over 4 years ago in reply to QJ Wang

TI__Mastermind 22235 points

Hi Wang,

May I know is there any updates about the new question?

Thanks!

Best Regards,

Cherry

0 Cherry Zhou over 4 years ago in reply to Cherry Zhou

TI__Mastermind 22235 points

Hi Wang,

Could you please take a moment to check the updates?

Thanks and expecting your reply!

Best Regards,

Cherry Zhou

0 QJ Wang over 4 years ago in reply to Cherry Zhou

TI__Guru**** 199456 points

Hi Cherry,

Sorry for closing the thread by clicking a wrong button.

I don't know other way to get into debug mode.

Arm-based microcontrollers

Arm-based microcontrollers forum

TMS570LS3137: How to put the system into halt debug mode through software configuration