AM2434: Links in the TMDSICE3359 demo board instruction sheet don’t work

Lauren Mayfield

Part Number: AM2434
Other Parts Discussed in Thread: AM3359, TMDSICE3359

Hi all,

Can you provide the updated links for these - they do not work in the demo board instructions.

If I type it into the browser, it just takes me to the default DSP page. https://www.ti.com/microcontrollers-mcus-processors/processors/digital-signal-processors/overview.html

Thanks!
Lauren

over 3 years ago

0 Ming Wei over 3 years ago

TI__Guru 55905 points

Hi Lauren,

Where did you get the demo board instructions? Is it in the MCU+SDK? Which version are you using.

Best regards,

Ming

0 Lauren Mayfield over 3 years ago in reply to Ming Wei

TI__Expert 7985 points

This is for the TMDSICE3359 demo board, they purchased two AM3359 Industrial Communications Engine TMDSICE3359 Hardware and Software Development Boards and these instructions came with it

0 Ming Wei over 3 years ago in reply to Lauren Mayfield

TI__Guru 55905 points

Hi Lauren,

I will forward this thread to the Sitara MPU. They should get back to you soon.

Best regards,

Ming

0 Dhaval Khandla over 3 years ago in reply to Ming Wei

TI__Mastermind 28164 points

Hi Lauren
You can use the following link : https://software-dl.ti.com/processor-industrial-sw/esd/docs/indsw/EtherCAT_Slave/01_00_10/PRU_ICSS_EtherCAT.html#running-ethercat-slave-application

Regards
Dhaval Khandla

Arm-based microcontrollers

Arm-based microcontrollers forum

AM2434: Links in the TMDSICE3359 demo board instruction sheet don’t work