MSP432E401Y: I cannot verify "NVM configuration" of PMIC-A on Scalable-PMIC-GUI

OBUCHI YOHEI

Part Number: MSP432E401Y
Other Parts Discussed in Thread: SCALABLE-PMIC-GUI, TDA4VM

Hello Expert.

Currently , I am checking PMIC NVM config of TDA4VM by Scalable-PMIC-GUI and TI LaunchPad.
I have question about "NVM configuration".

I want to read/write NVM config at PMIC-A(I2C address:0x48) and PMIC-B(I2C address:0x4C)
When I write config to PMIC-B , it was successfully.

When I write config to PMIC-A , it was failed. ( "Verify Connection" is failed.)

Q1 I don’t know why I cannot connent page0 at PMIC-A.

Could you tell me the reason?

best regards

over 3 years ago

+1 Phil Yi over 3 years ago

TI__Mastermind 48891 points

Hello,

Can you try unplug the USB cable and plug it back gain? or, if it's still not working, please try to restart the GUI again?

Thanks!

Phil

0 OBUCHI YOHEI over 3 years ago in reply to Phil Yi

Prodigy 210 points

Hello

Thank you for quick reply.
Connection with TI LaunchPad was incorrect.

0 Phil Yi over 3 years ago in reply to OBUCHI YOHEI

TI__Mastermind 48891 points

Hello,

What do you mean "was incorrect"? Do you mean the LaunchPad doesn't connect with the GUI? Can you try relaunch the GUI? Can you attach a picture to show the message from GUI?

Thanks!

Phil

Arm-based microcontrollers

Arm-based microcontrollers forum

MSP432E401Y: I cannot verify "NVM configuration" of PMIC-A on Scalable-PMIC-GUI