TMDSEMU200-U: DRA821U Device is supported or not

ytakano

Part Number: TMDSEMU200-U
Other Parts Discussed in Thread: TMDSEMU110-U, DRA821U, J721EXCPXEVM

Hello,

According to our customer, since TMDSEMU110-U is out of stock, they plan to purchase TMDSEMU200-U now.
https://www.ti.com/tool/TMDSEMU200-U

What customer would like to make sure is whether TMDSEMU200-U can support DRA821U.

Thanks,

over 3 years ago

+1 Karthik Ramanan over 3 years ago

TI__Guru** 113810 points

DRA821U should be supported by https://www.ti.com/tool/TMDSEMU200-U

We don't have one to validate immediately but it should work.

0 ytakano over 3 years ago in reply to Karthik Ramanan

TI__Genius 9095 points

One more question.

Customer is using J7200XSOMXEVM & J721EXCPXEVM with TMDSEMU110-U.

Can TMDSEMU200-U be connected to those EVMs?

Thanks,

0 Karthik Ramanan over 3 years ago in reply to ytakano

TI__Guru** 113810 points

There is an onboard XDS110 that comes with the common processor board J721EXCPXEVM that exposes the micro USB interface.

To connect the TMDSEMU200-U, you can use the JTAG interface with the right connector.

0 ytakano over 3 years ago in reply to Karthik Ramanan

TI__Genius 9095 points

Hi Karthik,

Sorry for my wrong information, but customer was planning to use J7200XSOMXEVM & J721EXCPXEVM with TMDSEMU110-U.
But TMDSEMU110-U is out of stock, then they are palnning to use TMDSEMU200-U instead of TMDSEMU110-U.

> To connect the TMDSEMU200-U, you can use the JTAG interface with the right connector.

What does the right connector mean?
Could you please give me some specific advice?

Thanks,

+1 Stanley Liu over 3 years ago in reply to ytakano

TI__Guru 50045 points

Customer does not need to buy extra JTAG pod when working with EVM.

You can find the USB connector marked as XDS110 on EVM and connect CCS with USB cable.

Regards,
Stanley

Arm-based microcontrollers

Arm-based microcontrollers forum

TMDSEMU200-U: DRA821U Device is supported or not