SYSCONFIG: Sysconfig

Muhammad Arsalan Athar

Part Number: SYSCONFIG
Other Parts Discussed in Thread: TMS320F28335, C2000WARE

I have just installed the sysconfig tool which is new to me. But it has no peripherals like Digital Control Library and the Analog to Digital Converter (ADC) in its panel. Please see the picture below.

Could you please suggest how to enable other peripheral features in my installed sysconfig tool like this ->

Thanks

Kind Regards

Arsalan

over 2 years ago

0 Cesar over 2 years ago

TI__Guru**** 150944 points

Hi,

What processor do you plan to use?

thank you

Cesar

0 Muhammad Arsalan Athar over 2 years ago in reply to Cesar

Intellectual 410 points

I am using TMS320F28335 Delfino board having f28335 card in its peripheral.

Regards

Arsalan

+1 Peter Luong1 over 2 years ago in reply to Muhammad Arsalan Athar

TI__Mastermind 19341 points

Hi Arsalan,

Make sure that you are using a software product (such as C2000Ware 4.03.00.00) when you launch the SysConfig GUI. If you don't do such, it will simply launch the pinmux tool without any capability to configure peripherals or use the included libraries.

Regards,

Peter

+1 Peter Luong1 over 2 years ago in reply to Peter Luong1

TI__Mastermind 19341 points

Hi Arsalan,

Actually I just took a closer look. The peripheral configuring capabilities are only present on our C2000 devices after F2837x family. You will need to use that device or a new generation 3 device. Otherwise, our older devices only support the general pin muxing capabilities in SysConfig

Regards,

Peter

Arm-based microcontrollers

Arm-based microcontrollers forum

SYSCONFIG: Sysconfig