LP-MSPM0G3507: PWM does not work on PA10

Jonas Eschenlohr

Hello,

I have made the following settings for PWM on pin PA10.

But I do not measure a PWM signal. If I leave all settings the same and only change the pin from PA10 to PB13, everything works as desired.

What do I have to do to use PA10 as PWM?

+1 Diego Abad Sajamin over 2 years ago

Hi Jonas,

I replicated this issue using the attached project, and I didn’t see the same error.

Please run the project I attached, and set J21 and J22 as the jumper configuration in the photo.

Let me know if it still doesn’t input the signal.

Best Regards,

Diego Abad

Arm-based microcontrollers forum