LP-AM243:Load the Ethernet program again, power off and power it on again

haojie.wu

Part Number: LP-AM243

Load the Ethernet program and connect it for the first time is OK. Rerun the program and print the following error. At this time, it is necessary to power off the LP-AM243 board and then power it on again.

over 2 years ago

0 Nilabh Anand over 2 years ago

TI__Guru 59660 points

Hi haojie,

It is necessary to do system reset for ENET based examples. Please see below for more details: e2e.ti.com/.../faq-mcu-plus-sdk-am243x-system-reset-is-needed-for-enet-icssg-cpsw-based-examples

0 haojie.wu over 2 years ago in reply to Nilabh Anand

Prodigy 135 points

HI ，

Run example enet_ Cpsw_ Tcpserver

LP-AM243 J19 Ethernet interface can operate normally, J18 cannot operate and cannot be connected

0 Nilabh Anand over 2 years ago in reply to haojie.wu

TI__Guru 59660 points

You need to power off and power on the board to make is run successfully again.

Arm-based microcontrollers

Arm-based microcontrollers forum

LP-AM243:Load the Ethernet program again, power off and power it on again