How to determine the value of IOMUX_PINCM( MSPM0G3507)?

jerly lei

Other Parts Discussed in Thread: SYSCONFIG

During the process of M0 software development, configuring the IOMUX_PINCM parameter is required. However, despite researching relevant documentation, I have been unable to find the proper procedure for configuring this parameter. Therefore, I would like to inquire about the recommended approach or guidelines for setting this parameter. Thank you.

over 2 years ago

+1 Diego Abad Sajamin over 2 years ago

TI__Genius 16432 points

Hi Jerly,
The way you configure IOMUX_PINCM will be on the MSPM0G350x Mixed-Signal Microcontrollers With CAN-FD Interface datasheet (Rev. A) Section 6.2 Pin Attribute.

You can see the PINCMx that corresponds to each PINA and PINB. If you mean how to code it, please refer to your ti_msp_dl_config.h file (which is created when you compile your SYSCONFIG file.) As the following image shows, the PINCMx is the pin that corresponds to the PINA or PINB you are configuring:

Best Regards,

Diego Abad

Arm-based microcontrollers

Arm-based microcontrollers forum

How to determine the value of IOMUX_PINCM( MSPM0G3507)?