MSPM0G1107: Boot issue

Cherry Zhou

Part Number: MSPM0G1107
Other Parts Discussed in Thread: SYSCONFIG

Hi Team,

PA18 and NRST have been pressed on development board and it have entered into boot mode. Using internal boot boot program can find the interface but it cannot be downloaded.

Could you please help check this case? Thanks.

Best Regards,

Cherry

over 2 years ago

0 Brandon Fisher94 over 2 years ago

TI__Mastermind 28075 points

Hi Cherry,

What revision of the launchpad is being used? It should be Rev. A for this version of the SDK.

Can you also verify that the J21 and J22 headers are populated in the XDS position (upper pin and center pin shorted).

Best Regards,
Brandon Fisher

0 switch over 2 years ago in reply to Brandon Fisher94

Genius 3960 points

Hi Cherry，

The ADC0_12 port is invalid in the IDE. Other I/O ports are valid.How do I configure it?

0 Brandon Fisher94 over 2 years ago in reply to switch

TI__Mastermind 28075 points

Hi Switch,

Is this related to the boot issue that Cherry was talking about? If not you may want to start a new thread in this forum and add some context on where you are seeing the ADC0_12 port as invalid.

Best Regards,
Brandon Fisher

0 Cherry Zhou over 2 years ago in reply to Brandon Fisher94

TI__Mastermind 22235 points

Hi Brandon Fisher,

Thank you for the confirmation. This issue indeed was originally raised by Switch on E2EChina forum, you could discuss this case with Switch for more information.

Thanks and Regards,

Cherry

0 Brandon Fisher94 over 2 years ago in reply to Cherry Zhou

TI__Mastermind 28075 points

Hi Switch,

Are you saying the ADC0_12 option is having an issue in the SysConfig, or is this an error you are seeing at build time?

Best Regards,
Brandon Fisher

Arm-based microcontrollers

Arm-based microcontrollers forum

MSPM0G1107: Boot issue