TMDSEMU110-U: FFSD-10-S-06.00-01-N instead of FFSD-05-S-04.00-01-N

HS FAE Germany

Part Number: TMDSEMU110-U

Hi,
customer claimed that the on the following JTAG Connector page (https://software-dl.ti.com/ccs/esd/documents/xdsdebugprobes/emu_jtag_connectors.html#cti-20-pin-header-information ) the

Samtec FFSD-05-S-04.00-01-N is not correct but the FFSD-10-S-06.00-01-N

Can you check this and change that on the webage?

Regards, Holger

over 2 years ago

0 Omer Amir over 2 years ago

TI__Mastermind 30185 points

Hello Holger,

I've made note for this change to be made. I'll mark this closed for now unless there are other updates.

Best regards,

Omer Amir

0 JohnS over 2 years ago in reply to Omer Amir

TI__Guru**** 162325 points

Holger,

FFSD-10-S-04.00-01-N is correct. The 04 vs the 06 refers to the cable length in inches. Our debug probes all use 4 inch cables. This length is recommended to avoid violating our maximum unbuffered connection constraint of 6 inches from probe to device.

Regards,

John

Arm-based microcontrollers

Arm-based microcontrollers forum

TMDSEMU110-U: FFSD-10-S-06.00-01-N instead of FFSD-05-S-04.00-01-N