MSPM0L1306: LP Set Up with External Debug Probe TMDSEMU110-U

Mari Tsunoda

Part Number: MSPM0L1306
Other Parts Discussed in Thread: TMDSEMU110-U,

Hi Team,

I am trying to set up the TMDSEMU110-U debug probe for the MSPM0 device, but I have been coming across this error message when I try to debug. The program will not load.

Can you help me out?

As for the board, I followed the following procedure on the MSPM0L1306 Users Guide

My board has jumpers on the J101 block GND and 3V3. I have connected the debug probe to the J103 block.

Best regards,
Mari Tsunoda

over 1 year ago

0 Dennis Lehman over 1 year ago

TI__Guru 70726 points

Hi Mari,

Is this a brand new Launchpad, or has it been programmed before? If you remove the XDS110 and put the J101 jumpers back, can you connect and program using the on-board XDS Launchpad programmer?

0 Dennis Lehman over 1 year ago in reply to Dennis Lehman

TI__Guru 70726 points

Hi Mari,

Any updates?

0 Mari Tsunoda over 1 year ago in reply to Dennis Lehman

TI__Expert 5726 points

Hi Dennis,

Sorry for my late reply. I didn't have the chance to get back to this recently. It is a new LaunchPad.

Yes, I had no issues when I re-connected the jumpers.

Best regards,

Mari Tsunoda

Arm-based microcontrollers

Arm-based microcontrollers forum

MSPM0L1306: LP Set Up with External Debug Probe TMDSEMU110-U