LP-MSPM0G3507: Handling ECC when using a programmer like MSP GANG

kei

Part Number: LP-MSPM0G3507

Hello.

I want to use MSPM0 to design for mass production.
MSPM0 has an ECC function, so it is necessary to manage ECC codes correctly.

I would like to know how to configure ECC in a programmer tool like MSP GANG.

Thank you.

over 2 years ago

0 Eason Zhou over 2 years ago

TI__Mastermind 39875 points

You just need to program the code in a certain memory

0 kei over 2 years ago in reply to Eason Zhou

Intellectual 685 points

thank you.

Will this ECC code part be programmed as well?

+1 Eason Zhou over 2 years ago in reply to kei

TI__Mastermind 39875 points

No, it won't. I think your datasheet is not the latest version. The memory pointed by you is for peripheral(Which you don't need to care about), not for code.

Arm-based microcontrollers

Arm-based microcontrollers forum

LP-MSPM0G3507: Handling ECC when using a programmer like MSP GANG