• State
  • Locked Locked
  • Replies 6 replies
  • Subscribers 30 subscribers
  • Views 383 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSPM0L1305: Flashed the code does not run after power reset

santhosh prem
Intellectual 340 points
Part Number: MSPM0L1305
Other Parts Discussed in Thread: SYSCONFIG, , MSPM0L1306

Hi Team,

 

I loaded my code into the microcontroller using the Load Program , and it is working as expected. However, when I perform a power-on reset, I am unable to observe any output in the terminal.

can you Please help me regrading this ASAP

  • 0
    TI__Guru 70586 points

    Hi Santhosh,

    Tell me about your set.  Using CCS? version of SDK, Sysconfig.  What are you using to program the target? XDS110, JLink, etc.

  • 0 in reply to Dennis Lehman
    Intellectual 340 points

    Hi Dennis,

    Thank you so much for the reply,

    I am using:

    • CCS version: 12.5.0
    • SDK: mspm0_sdk_1_30_00_03
    • Sysconfig: 1.18.0
    • I am using the XDS110 debug probe to flash.
  • 0 in reply to santhosh prem
    TI__Guru 70586 points

    Hi Santhosh,

    Are you able to share your code?  You can share it privately if needed.

  • 0 in reply to Dennis Lehman
    Intellectual 340 points

    Hi Dennis,

    sorry for the delay, I was conducting testing on the UART LIN  to confirm the power reset issue, as I am currently working on the UART LIN,so I used example code from the SDK to verify it first

    I flashed the lin commander code(Debug-> .out) onto the microcontroller,. I am able to observe the output in CANoe as describe in Readme(press switch1 to see the transmission)

    However, when I power off the Eval-board and my power supply(12 v), then power it on again, I am unable to observe the output in CANOe

    I am not sure what mistake I am making, can you Please help me with this issue regarding this Please ASAP because It's crucial for me to resolve it quickly

    you may ask whether GPIO Toggle is working after power reset;yes,it is working on  the microcontroller

    I am using 

    • CCS version: 12.5.0
    • SDK: mspm0_sdk_1_30_00_03
    • Sysconfig: 1.18.0
    • microcontroller - Eval board(MSPM0L1306) for Testing since I dont have the MSPM0L1305 Eval Board
    • I am using the XDS110 debug probe to flash.
    • I used LIN Enable Pin as PA27
  • 0 in reply to santhosh prem
    Intellectual 340 points

    Hi Dennis,

    Can you Please reply for this 

  • 0 in reply to santhosh prem
    TI__Guru 70586 points

    Hi Santhosh,

    I apologize for the delayed response.

    If you are still having issues after you have removed the debugger from the circuit and cycle power, check what is the voltage on the NRST pin.  You should have a pull up resistor (47K typ) tied to VDD.