TMS570LC4357: Propagation delay for ISOW1044 CAN transceiver

Hi Karthik,

This propagation delay is used to calculate CAN bit timing. Since the CAN controller manages the bus access through bit-wise arbitration, it must be assured that the signal propagation time from sender to receiver and back to the sender must be completed within one bit time.

(+) TMS570LS3137: CAN message transmit interval setting issue - Arm-based microcontrollers forum - Arm-based microcontrollers - TI E2E support forums

"The physical delay in the Propagation delay is application specific. The default value in HALCoGen is just an example calculated for a certain transceiver. The customer should figure out and reflects the physical delay on the CAN network including transceivers etc.."

--

Thanks & regards,
Jagadish.