MSPM0G1505: swd error-614

SURESHAN .K

The target indicates there is an error condition from a previous SWD request. Clear the error the condition, and try the SWD request again.

facing this error. how to solve it?

edit :

changed the mcu getting new error

it is working fine when i program the launchpad mcu but not otherwise.

over 1 year ago

+1 Janz Bai over 1 year ago

TI__Genius 11050 points

Hello

I am out of office today, and I will help you to solve this problem and reply to you in this week.

Best regards,

Janz Bai

0 Janz Bai over 1 year ago

TI__Genius 11050 points

Hello,

If you don't use the LaunchPad and use your own PCB board. You need to check the design of the SWD interface on your board and then check the connection of your board and the debugger. If you used the XDS110, maybe you can try to use another one to do it again.

Best Regards,

Janz Bai

0 Janz Bai over 1 year ago in reply to Janz Bai

TI__Genius 11050 points

And maybe you can try to unlock the M0 through the method mentioned in the slides.3414.Unlock MSPM0 1.1.pptx

Arm-based microcontrollers

Arm-based microcontrollers forum

MSPM0G1505: swd error-614