LP-AM243:How to deal with Error 6305

Yukinobu Hasinoguti

Intellectual 300 points

Part Number: LP-AM243
Other Parts Discussed in Thread: UNIFLASH

Tool/software:

HiWhen I try to connect to LP-AM243x with sbl null flashed in CCS (Version: 12.7.1.00001),

Hi,

I get an error and cannot connect to the target.

I deleted "AM243x_XDS110.ccxml" in targetConfiguration and created it again,

but the same error occurred.

Please let me know how to deal with this error.

Regards,
Yukinobu

over 1 year ago

0 Vaibhav Kumar over 1 year ago

TI__Mastermind 44346 points

Hello Yukinobu,

There are many reasons why this could occur.

So we need to find the root cause for this.

What I want you to do is firstly go ahead click on "Test Connection", if this is successful, then we can move ahead.

Also based on your screenshot, it looks like when you select launch target configuration that is successful but when you click on R50_0 core and try connecting to the core, then it is failing?

Regards,

Vaibhav

0 Yukinobu Hasinoguti over 1 year ago in reply to Vaibhav Kumar

Intellectual 300 points

Hi Vaibhav,

Vaibhav Kumar said:
Also based on your screenshot, it looks like when you select launch target configuration that is successful but when you click on R50_0 core and try connecting to the core, then it is failing?

Yes.
Flash sbl_null with added processing to loop,
I tried to connect from CCS to R5_0_0, but I get an error.

Regards,
Yukinobu

0 Vaibhav Kumar over 1 year ago in reply to Yukinobu Hasinoguti

TI__Mastermind 44346 points

Hello Yukinobu,

Can you let me know if python uart uniflash command works fine for you? I am assuming you already flashed sbl null via uart uniflash.

Yukinobu Hasinoguti said:
Flash sbl_null with added processing to loop,

So its like you added the code of loop_forever() in sbl null?

If my understanding is correct, then you should be able to connect to the R5 core and load the symbols which is basically going to be your .out file.

And from this point onwards you should be able to debug.

Looking forward to your response.

Regards,

Vaibhav

0 Yukinobu Hasinoguti over 1 year ago in reply to Vaibhav Kumar

Intellectual 300 points

Hi Vaibhav,

Vaibhav Kumar said:
So its like you added the code of loop_forever() in sbl null?

Yes.
I added the loop_forever() code to debug.

Vaibhav Kumar said:
If my understanding is correct, then you should be able to connect to the R5 core and load the symbols which is basically going to be your .out file.

Cannot attach to R5 core (R5_0_0). Therefore, debugging is not possible.

Here is my procedure.
1.Select Launch Selected Configuration from Target Configurations.