AM2634: How to get xds100 out of DFU mode

Ajit Ladgaonkar

Part Number: AM2634

Tool/software:

Hi Team,

I have switched mode of XDS110 to DFU mode. Please let me know how to get it out of DFU mode.

Also, please let me know complete procedure to use XDS110. We have assembled AM2634 on board and trying to load the code through XDS110 module.

Thanks for the support!

0 Fleenor 8 months ago

Hey Ajit,

The XDSDFU utility should be used in this case. The XDS110 will exit DFU mode upon successful boot after flashing a valid firmware image.

Instructions and further information can be found at the page below.

Hope this helps get you moving forward and glad to address any additional questions you may have.

Best Regards,

Zackary Fleenor

Arm-based microcontrollers forum