AM263P4-Q1: Boot Mode Selection to Retain Program Memory in OCRAM on Power Reset

Tool/software:

Hello,

I am currently using DEV_BOOT mode on my controller. However, I face an issue where every time I perform a Power-On Reset (POR) to start a debug session, the program memory resets since it is stored in OCRAM.

Could you please guide me on:

1. Which boot mode should I select to retain the program memory/code even after a power reset?
2. Any necessary configurations or settings that I need to modify to achieve this?

Any insights or recommendations would be greatly appreciated.

Thank you!

Regards,

Tarun