Tool/software:
Hello,
We are using the LP-AM263P development kit and example project mcan_loopback_interrupt_am263px-lp_r5fss0-0_freertos_ti-arm-clang. We cannot debug the project and we are not sure that the project runs properly.
Could you please help to debug and run the project?
Best regards,
Egemen
Hello Nilabh,
We tried every step but we can not flash the LP-AM263P.
Is there anything else that we are missing?
Best regards,
Egemen
Hi Egemen,
I checked this on my setup, I was able to figure out the issue.
It is because of stale binary in Uniflash tool. you can check is using the flashed present in SDK instead of the default one: software-dl.ti.com/.../TI_UNIFLASH_TOOL.html
Steps :1 Build the jtag flasher example for AM263Px-LP
Then use the freshly built .out for custom flasher in Uniflash:
C:\ti\mcu_plus_sdk_am263px_10_00_00_35\tools\flasher\jtag_uniflash\am263px-lp\r5fss0-0_nortos\ti-arm-clang
OR
you can get unblocked by using UART COM port for flashing.:
In the drop down of device Search for AM263Px-LP(Serial), then select the com port
