AM263P4-Q1: Debug Log Change Saved Location from SRAM or Reduce Size

Mari Tsunoda

Part Number: AM263P4-Q1
Other Parts Discussed in Thread: SYSCONFIG

Tool/software:

Hi Team,

Is there a way to configure in sysconfig to NOT save the debug log in shared memory?

If it is not possible to do this, is there a way to reduce the size of the debug log saved on shared memory?

Best regards,

Mari Tsunoda

0 Aswin Sankar 7 months ago

Hi Mari,

In sysconfig, there is an option to enable/disable the debug log.

You can find it at TI DRIVERS PORTING LAYER > Debug Log > Enable Shared Memory Log Writer.

You can disable this option to not save any debug logs in shared memory.

Regards,

Aswin

0 Mari Tsunoda 7 months ago in reply to Aswin Sankar

Hi Aswin,

Thanks for the quick response.

Is there any way to save it in any other location other than shared memory?

Best regards,

Mari

+1 Aswin Sankar 7 months ago in reply to Mari Tsunoda

Hi Mari,

This is possible. Please follows the steps below to do so.

1. Go to Sysconfig > Memory Configurator > Memory Region > Region > LOG_SHM_MEM

2. You can choose in which memory to write by choosing the same from the dop down box in the Type field

3. To change the address, you can change the Start Address in the same option.

Regards,

Aswin

Arm-based microcontrollers forum