TMS 570 MDK Parallel I/O

Rob Corcoran

We have an external I/O card with DPRAM which we'll need access to from the TMS570MDK. What is the best method for bringing out 12 address lines and data lines, with read/write lines, for this purpose?

over 14 years ago

0 QJ Wang over 14 years ago

TI__Guru**** 200206 points

Hi Rob，

For Keil TMS570MDK, all the EMIF address, data, and control signals are located on P2 connectors. TMS570LS2x on Keil TMS570MDK doesn't support synchronous DPRAM.

Regards,

0 Pratip Kumar over 14 years ago in reply to QJ Wang

TI__Intellectual 2285 points

Rob,

Does this answer your question ?

Click on verify Answer if your questioin is answered.

- Pratip

0 Rob Corcoran over 14 years ago in reply to QJ Wang

Prodigy 120 points

Thanks QJ. I believe this answers my question. DPRAM was intended to refer to Dual Port RAM - static in the configuration I was looking to support, not SDRAM, so the EMIF should be suitable for our needs.

Rob

Arm-based microcontrollers

Arm-based microcontrollers forum

TMS 570 MDK Parallel I/O