Tool/software:
Hello, this is JJ
I want to reset the software and to be run from initial start.
After clicking the RESET button several times in the eval board, these errors occured.
RESET button is just connected with the MCU, I don't know the reason.
Please let me know,
Best Regards,
JJ
Hi JJ,
Are you doing reset through switch while you are in debug mode?
If yes, then don't do that, instead of you can do reset in CCS debug window itself. Click on below highlighted option:
Make sure you pause the code before clicking on above option.
If you click on this then your code directly points to the reset vector like as shown below:
Now you can click on resume to continue execution from this start over.
--
Thanks & regards,
Jagadish.
