MSPM0L1106: Firmware Flashing error for MSPM0L1106 Custom Board

Selva Subramanian

Prodigy 10 points

Part Number: MSPM0L1106

Tool/software:

Hi Team,

I have a custom board with the pins as per the image taken out for debugging/ program flashing.

While flashing, I'm encountering the following issues.

1. Texas Instruments XDS110 USB Debug Probe/CS_DAP_0 Error connecting to the target: (Error -616 @ 0x0) The data received from the target may be corrupt. The connection to the target may be unreliable. Try lowering the TCLK setting before trying again. (Emulation package 20.0.0.3344)
2. Texas Instruments XDS110 USB Debug Probe/CORTEX_M0P Error connecting to the target: (Error -6311) PRSC module failed to write to a register. (Emulation package 20.0.0.3344)

However, the test connetion has been succeeded.

4 months ago

0 JOJO ARTHUR 4 months ago

TI__Intellectual 940 points

Hello Selva,

Thank you for contacting us. We have a page for troubleshooting common JTAG connectivity issues, including the one you are seeing: https://software-dl.ti.com/ccs/esd/documents/ccs_debugging_jtag_connectivity_issues.html#incorrect-swd-header. As that page notes, it is possible for the second issue to be caused by Debug Probe is mistakenly configured to use 4-wire JTAG. Can you ensure that is not the case?

For the first issue, I would advise using a lower clock setting or also using shorter jumper wires to verify if the error is still seen.

Regards, Jojo

Arm-based microcontrollers

Arm-based microcontrollers forum

MSPM0L1106: Firmware Flashing error for MSPM0L1106 Custom Board