Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed the week of November 23.

MSPM33C321A-Q1: mounting a smaller flash device in same PCB , any check needed

Part Number: MSPM33C321A-Q1
Other Parts Discussed in Thread: SYSCONFIG, MSPM33C321A

Hi Everybody , 

I have samples of M33C321A ( 1MB of flash ) mounting on my PCB  .

now in longer term I m going to use M33C3219   so w 512K of Flash ( my code is smaller then 512KB )

any reccomendation or needs  when moving my code ? 

 anything I should double check  ( like  ID , etc ) ?

thank you 

BR
Carlo

 

  • Hi Carlo

    Yes, in most cases, just selecting the new part number in your IDE (like CCS or Keil) and rebuilding is enough. The IDE will automatically update the header files and default linker script.
    Just double-check three things after rebuilding:
    • Custom linker scripts: If you modified your .cmd or .ld file earlier, the IDE won't overwrite it. Make sure the Flash size is updated to 0x80000 (512KB).
    • SysConfig: If you use .syscfg, open it and click Switch in the top right to update the device there too.
    • Predefined symbols: Check your project settings to make sure no old device macro (like __MSPM33C321A__) is left behind.
    Watch out for the Device ID though—both chips share the exact same DEVICEID (0xBBBC at 0x8011.1004), so you can't tell the 1MB and 512KB parts apart that way.
    You have to read USERID instead:
    • 1MB (M33C321A): PART is 0x9C7C, VARIANT is 0x44–0x47
    • 512KB (M33C3219): PART is 0x6936, VARIANT is 0x48–0x51
    Just make sure to update any ID checks in your firmware or production programmer from DEVICEID to USERID
    Thanks
  • Hi Xiadong 

    THANK YOU !  very clear , understood 

    BR

    Carlo

  • Hi Carlo

    Thanks for your feedback. Please click "solved" on this thread.