HALCoGen Ethernet Driver and lwIP Integration Demonstration

Hello Subramanya,

We are looking into this question.

Regards,

Diwakar

Subramanya,

Please provide a dump of the output on the console. BTW, are you using a crossover cable or a straight cable?

Regards,
Pramod

Hi, 

In the console, i didn't get any message apart from "CortexR4: GEL Output: Memory Map Setup for Flash @ Address 0x0".

And I'm using a Category 5(twisted pair cable). I guess it is not a crossover cable (But i'm not sure)

But actually, what am I supposed to do after building this project in order to establish the connection?

I did all the hardware setup mentioned in that wiki page. 

Am i supposed to do any modifications in the code ?

Thanks and regards

Subramanya 

Subramanya,

I was referring to the serial console output (SCI) on the PC. For details refer to the last screenshot on the Wiki Page.

Regards,
Pramod 

Hi Pramod, 

Actually that was  a blank screen. 

Could anyone please guide me with this demo project.

I did Connect ethernet port on HDK to a network with DHCP Server, enabled the Ethernet on EVM by setting switch S2 bit4 to On and Connected the JTAG USB port to PC. 
After debug, i dont get any message on the console.
What else am I supposed to do? 

Pramod,

Its working now.

The problem was i was using a different COM port. So i never got any messages on the console. 

. 

Now, here are the 2 o/p messages of console. The first one is the o/p when i used my laptop as DHCP server. (by running dhcpsrv2.3)
2nd one is using a router. 
what could possibly be the problem of initializing the hardware in the first case?? 

Pramod,

Yes,
That was the problem. DHCP server is not providing IP address for any devices connected. I'll try it with any other software and try to make it work.

This demo project was quite helpful. Thanks for that.