MibSpi: Compatibility-Mode not selectable in HalCoGen

flurin.buehler

Other Parts Discussed in Thread: HALCOGEN

Hello

I am using MibSpi1 in compatibility mode. Using HalCoGen 3.6.0 I did not find out how to configure MibSpi1 to run in compatibility mode.Is there another way except manually modifying the generated code?

Best regards

Flurin Bühler

over 12 years ago

0 Eric Brundick over 12 years ago

Guru 12956 points

Enable SPI1, not MibSPI1 ... in the SPI1 tab it says:

Note

-SPI1 is Compatibility Mode of MIBSPI1

0 flurin.buehler over 12 years ago in reply to Eric Brundick

Intellectual 280 points

Hi Eric

Thank you for your reply. I tried it with the following result:
- initialization of MibSpi1 is removed from mibspi.c -> ok
- spi.h/spi.c is generated -> ok
- in Halcogen I can not use all mibspi-pins as gpios -> not ok

Do you know a workaround for this, too?

Regards,

Flurin

Arm-based microcontrollers

Arm-based microcontrollers forum

MibSpi: Compatibility-Mode not selectable in HalCoGen