NHET interrupts for rising edge monitoring

Aditi Singh

Other Parts Discussed in Thread: HALCOGEN

I am using N2HET[0],N2HET[1], and N2HET[2] as interrupts. They should be able to access the rising edge.

How do I initialize or set directions for them?

I am quite new to microcontroller coding.

0 Jan Cumps over 11 years ago

Guru 15740 points

Are you using HALCoGen to initialize HET?

In that case, there is a Edge 0-7 tab where this can be defined.

0 Aditi Singh over 11 years ago in reply to Jan Cumps

Yeah, I did the settings.

I have enabled HET , GIO and RTI driver.

Are my settings fine? How can we handle more than one interrupts at a time?

I want to know the time difference between two interrupts getting rising edge?

Arm-based microcontrollers forum