Can I use DK-TM4C129X for debugging code on my hardware?

Hemant Kamat1

Other Parts Discussed in Thread: LM3S8962

Hello,

Can I use the DK-TM4C129X kit for debugging my hardware and firmware just like the LM3S8962 kit? By this Imean, can I use the pass through JTAG ICDI to debug my hardware and firmware.

Thanks for your time.

Hemant

over 12 years ago

0 Roberto Romano over 12 years ago

Guru 27285 points

Reading user manual .. on page 6 report:

Debug
– Tiva In-Circuit Debug Interface (ICDI)
– Standard 20-pin JTAG header without ETM functionality (debug in and out capable)

So JTAG connector appear as programmer or programming interface depending on selected direction.

0 Hemant Kamat1 over 12 years ago in reply to Roberto Romano

Intellectual 535 points

Dear Roberto,

Thanks for the answer.

Regards

Arm-based microcontrollers

Arm-based microcontrollers forum

Can I use DK-TM4C129X for debugging code on my hardware?