LM Flash Programmer bug ?

Markel Robregado

Hi,

I have this odd problem with my LM Flash Programmer. Special characters appear at the 'Select .bin file text box". See, below.

-kel

over 12 years ago

0 Markel Robregado over 12 years ago

Guru 86865 points

The problem go away, when I close then re-open LM Flash Programmer. I have encountered this problem two times. I think this is just a minor glitch.

-kel

0 Stellaris Ken over 12 years ago

TI__Expert 3555 points

Hi kel,

I have been able to reproduce this on my system in a slightly different way. It seems an extra special character or two occasionally gets appended to the previous program file name.

I agree it is minor in that you can delete the characters or browse to the needed file.

I will open up an internal bug to have this looked at for the next release.

- Ken

0 Markel Robregado over 12 years ago in reply to Stellaris Ken

Guru 86865 points

Hi,

This rarely happens at my PC. At the firs time, I remember there was an event during my code testing. Anyway, TI engineers will figure it out.

-kel

0 Markel Robregado over 12 years ago in reply to Markel Robregado

Guru 86865 points

Hi,

I just opened my LM Flash Programmer and got the problem again. I just noticed that it also happens at Flash Utilities tab and Other Utilities tab of the LM Flash Programmer. See, below. Good luck with regards to this problem.

-kel

Arm-based microcontrollers

Arm-based microcontrollers forum

LM Flash Programmer bug ?