Waveform wizard

Furkan Aydogan1

I am getting started HET IDE release 3.3. I am following steps at NHET Getting Started Tutorial but box which would open the waveform wizard is grayed out. Is that any extra tool for waveform wizard ?

over 11 years ago

0 Enrique Lizarraga over 11 years ago

TI__Expert 4580 points

We have received your post and we will be back to you soon.

Regards.

0 Haixiao Weng over 11 years ago

TI__Genius 13810 points

Did you get some warnings when you start the program?

Can you post a screen shot?

Regards,

Haixiao

0 Furkan Aydogan1 over 11 years ago in reply to Haixiao Weng

Intellectual 450 points

Sometimes i am getting this error.

0 Haixiao Weng over 11 years ago in reply to Furkan Aydogan1

TI__Genius 13810 points

Did you use Juniper VPN?

The Juniper VPN (or some other programs) that got pushed to on our PCs uses the same port 4242 by default.

You can terminate the Juniper VPN process (unless you're using it!) and then use the HET IDE.

We will post an update version of HET IDE eventually.

Regards,

Haixiao

0 Furkan Aydogan1 over 11 years ago in reply to Haixiao Weng

Intellectual 450 points

I am not using any VPN program. When i don't see this error simulation works perfectly but since two days i could not load any program.

Thanks.

0 Anthony F. Seely over 11 years ago in reply to Furkan Aydogan1

TI__Guru 68920 points

Furkan,

It might not be a VPN program - but some other program that uses the same port.

You can try the attached executables. Download these 0447.HET.zip and paste them over your current HET IDE installation.

Where ever you have the HET IDE installed, for example C:\Texas Instruments\Hercules\HET call this <install dir>.

Save HET.exe over top of <install dir>\HET.exe
Save Simulator.exe over top of <install dir>\bin\Simulator.exe.

These executables have been patched to use a dynamic port # instead of a fixed port 4242 ... the fixed port # can cause a problem if some other app like a VPN is also using the port. In TI we've got a VPN program using this port, but I also found that a web meeting program was using this port.

Anyway, when you have these executables patched you should see this message now:

Except the port # will probably be something different, it'll be whatever's free on your PC ...

0 Furkan Aydogan1 over 11 years ago in reply to Anthony F. Seely

Intellectual 450 points

Using dynamic port for communication is a good solution. Now simulation and IDE working great.

Thanks for helpful answer.

0 Jan Cumps over 11 years ago in reply to Furkan Aydogan1

Guru 15740 points

I'm confirming that the patch solved the issue for me too. The waveform button is now enabled and I can see the waveform in SynaptiCAD.

Thank you!

Arm-based microcontrollers

Arm-based microcontrollers forum

Waveform wizard