flash programming of XM4C1294NCPDTI2

Hello Dhanush,

You can use CCS to compile and program. If you have a bin file ready then you can use the LMFlashProgrammer.

What is the IDE that you are using: CCS, Kiel, IAR, etc?

Regards

Amit

Dear sir ,

   You have not got my question please read my question again. I have made my own XM4C1294NCPDTI2 pic and i want to program my own code in it. I tried to program it with my DK TM4C129x kit  and LM flash prog,but i failed. Tell me how to program it.

Regards

Dhanush

Hello Dhanush,

Are you using the DEBUG OUT from DK-TM4C129K to program XM4C1294NCPDTI2. Can you check if the JTAG lines are getting activated?

Regards

Amit

Dear sir 

   I have not connected  DEBUG OUT of DK-TM4C129x. In our TI's DK-TM4C129x. kit there are two controller 

1.TM4C129

2.TM4c123

TM4c123 is used for debugging and programming of TM4C129 controller. I removed jumper of (TCK ,TDI ,TDO, TMS ) in between and i connected it with my  XM4C1294NCPDTI2's TCK ,TDI ,TDO, TMS pins.I made both's ground common.Then it ried to program it with our LM Flash programmer,but it is not working.

     Its very urgent sir please help us.

Hello Dhanush

Section 2.3.1 of the 129 User Guide mentions the connections that need to be done for Debug Out

I suggest a good read through and connection check.

Regards

Amit