Break points manager

Ahmed Mokhtar

Hello,

I am using CCS V 5.4 , 123GH6PGE DK and Tivaware 2.1 while iam debugging any application if i tried to set more than 3 brekapoints iget that error

CORTEX_M4_0: Breakpoint Manager: Error enabling this function: There is no AET resource to support this job.

over 11 years ago

0 Markel Robregado over 11 years ago

Guru 86765 points

Hi Ahmed,

See, wiki below. See, under "Hardware Breakpoints Limitations"

http://processors.wiki.ti.com/index.php/Stellaris_support_in_CCS

-kel

0 cb1_mobile over 11 years ago

Guru 117855 points

IAR allows 5 break-points before alerting - then classifying subsequent ones as, "software break-points." Three does seem too limited - perhaps your IDE's documentation enables an increase in their number - or a differently managed break-point format.

Always best to "start" from "official, known-good, IDE provided project" rather than your own, customized creation...

0 Ahmed Mokhtar over 11 years ago in reply to Markel Robregado

Intellectual 490 points

Hi Markel,

Thanks for your reply.i only could use only 3 breakpoints and i got that error in case of SW or HW Breakpoints

Arm-based microcontrollers

Arm-based microcontrollers forum

Break points manager