tiva c series programmer

mohamadreza sarbandi

Other Parts Discussed in Thread: TM4C123GH6PGE

Hi all;

I am going to design board with TM4C123GH6PGE.

my question is which programmer support this series?

J-Link or xds510 or ...?!

0 Markel Robregado over 11 years ago

Guru 86755 points

Hi,

Depends on your IDE. What IDE are you using for TM4C123G development? CCS? Keil? IAR?

If using CCS, you can check the wiki or application note for supported debug interface.

-kel

0 mohamadreza sarbandi over 11 years ago in reply to Markel Robregado

Hi;

thanks for replying...

this is my first experience to design Board with TI ARM, which IDE do you suggest ?

i want to use CCS and i have J link programmer...

0 Markel Robregado over 11 years ago in reply to mohamadreza sarbandi

Guru 86755 points

mohamadreza sarbandi said:
which IDE do you suggest ?

Depends on your development requirements and what you can afford. I suggest you compare features and prices.

mohamadreza sarbandi said:
i want to use CCS and i have J link programmer...

As far as I know, J-link is for Keil Uvision.

-kel

0 mohamadreza sarbandi over 11 years ago in reply to Markel Robregado

Ok...

this link said that J link also support with CCS

is XDS510 can debug Tiva C series? where can i see the devices that support with XDS510?

Arm-based microcontrollers forum