tm4c1233h6pm and LM4f120h5qr

Hi Kelvin,

     From what I know the LM4F was re-branded or re-named to its equivalent Tiva Microcontroller. So, it's just the same. If you use the latest Tivaware for your EK-LM4F120XL, it will still work even if some preprocessor defines have been changed from LM4F to its equivalent TM4C.

- kel

Hi,

For fast references, I keep the picture below on my desktop:

Petrei

hi petrei, thank for the reference

i were worried that is if i written my code completely and yet convert it from lm4f to tiva may have problem occur, therefore i wanna verified can the code be same or totally different, thank

Hello Kelvin,

As Kel and Petrei mentioned there are only two pre processor that need to be taken into account

PART_TM4C123xxx (as per the look up table Petrei mentioned)

TARGET_IS_TM4C123_RB1 (as the launchpad has a Revision-B1 device)

Do make sure that the defines mentioned above replace the existing equivalent LM4F define

Regards

Amit

Petrei said:

For fast references, I keep the picture below on my desktop:

There used to be a sticky post with this table. Now it is not sticky anymore.

- kel

Hello Kel,

It may have been made sticky for a year and then it moved before we could realize. I was able to get the literature on the same.

http://www.ti.com/lit/ml/spmt284/spmt284.pdf

I would need to add it to the Startup Note.

Regards

Amit