CCSV5 error connecting to target

Burhan Wani

Prodigy 50 points

Other Parts Discussed in Thread: LMFLASHPROGRAMMER

I have attached the log files.. please help.

7673.nn.zip

over 11 years ago

0 Amit Ashara over 11 years ago

TI__Guru**** 244400 points

Hello Burhan,

Can you be more specific on what exactly is the issue with information on debugger, TM4C device, etc.

Regards

Amit

0 Burhan Wani over 11 years ago in reply to Amit Ashara

Prodigy 50 points

it was running perfectly until yesterday when i ran a program. after that, it shows error connecting to target and then the ccs crashes. surprisingly it shows output on the virtual com port (teraterm) connected to uart0 even when it says error connecting to target.. i tried to make new workspaces, clear the cache by changing the target file to .exe -clean . but nothing is working

0 Amit Ashara over 11 years ago in reply to Burhan Wani

TI__Guru**** 244400 points

Hello Burhan,

Can you check the following Link. There would be the JTAG Pin and LM Flash Programmer Tips that would be useful.

http://e2e.ti.com/support/microcontrollers/tiva_arm/f/908/t/374640.aspx

Regards

Amit

0 Burhan Wani over 11 years ago in reply to Amit Ashara

Prodigy 50 points

Lmflashprogrammer did the job.. thank you so much.. i was worried that I might have messed up my board

Arm-based microcontrollers

Arm-based microcontrollers forum

CCSV5 error connecting to target