using EB-LM4F120-L35 with Tiva c TM4C123GLX

Ballenahalli Lokesh

Hi,

I am planning of buying a LCD TM4C123GLX for Tiva c series TM4C123GLX but the product EB-LM4F120-L35 in Kentec website states that the EB-LM4F120-L35 is for Stellarils BoosterPack.

I just wanted to know that whether I can use EB-LM4F120-L35 with Tiva c series TM4C123GLX launchpad.

Best Regards,

Lokesh

over 10 years ago

0 Amit Ashara over 10 years ago

TI__Guru**** 244400 points

Hello Lokesh,

This is for the TM4C129 and not the TM4C123. It comes on the DK-TM4C129 EVM

Regards

Amit

0 Ballenahalli Lokesh over 10 years ago in reply to Amit Ashara

Intellectual 270 points

Hi Amit,

Thank you for the replay

Can I know which lcd should I use for TM4C123GM

In the workshop which is provided online used EB-LM4F120-L35 for Tiva c TM4C123GM,

So bit confused could you please suggest the lcd touch screen which I can use with tm4c123gm.

Regards

Lokesh

0 Amit Ashara over 10 years ago in reply to Ballenahalli Lokesh

TI__Guru**** 244400 points

Hello Lokesh,

You can refer to the DK-TM4C123. It has a on-board 96x64 OLED screen and the grlib is supported for the same.

Regards

Amit

0 Markel Robregado over 10 years ago in reply to Ballenahalli Lokesh

Guru 86745 points

Ballenahalli Lokesh said:
In the workshop which is provided online used EB-LM4F120-L35 for Tiva c TM4C123GM,

I remember that workshop before. But, that workshop used the older version Tiva Launchpad. So, most likely the EB-LM4F120-L35 will work with the current Tiva Launchpad. To be sure check the pin compatibility of Tiva Launchpad and EB-LM4F120-L35.

- kel

0 Amit Ashara over 10 years ago in reply to Markel Robregado

TI__Guru**** 244400 points

Hello Kel,

I am more concerned on the grlib drivers. The interface may be bit-banged but getting grlib would be important;

Regards

Amit

Arm-based microcontrollers

Arm-based microcontrollers forum

using EB-LM4F120-L35 with Tiva c TM4C123GLX