Flash timeout ,Reset the target and try, it again in Tm4c123gh6pz

Rashmi yc

Other Parts Discussed in Thread: TM4C123GH6PZ

Hi..i'm using Tm4c123gh6pz with 8Mhz crystal. . i'm using keil version.5 compiler and j-link debugger...when i start to download then i'm getting the Flash timeout,Reset the target and try it again.after some time controller is heating up.Give some solution please..

over 10 years ago

Amit Ashara over 10 years ago

TI__Guru**** 244400 points

Hello Rashmi,

I believe you are doing a custom board. You may want to look up as to how you have connected JTAG, the VDDC power rail and Reset pin

Regards
Amit

Rashmi yc over 10 years ago in reply to Amit Ashara

Intellectual 830 points

Hi.. Every thing i have connected properly.And also my controller heating up after some time..

Amit Ashara over 10 years ago in reply to Rashmi yc

TI__Guru**** 244400 points

Hello Rashmi,

Can you share the schematic and the Keil JTAG Header information?

Regards
Amit

Rashmi yc over 10 years ago in reply to Amit Ashara

Intellectual 830 points

Hi..sorry for late response..i have replaced the controller..now it is working fine..

Arm-based microcontrollers

Arm-based microcontrollers forum

Flash timeout ,Reset the target and try, it again in Tm4c123gh6pz